ACR Electronics RCL-100 SEARCHLIGHT Manuel d'utilisateur

Y1-03-0266 Rev. A Page | 1 TROUBLE SHOOTING AND PARTS REPLACEMENT MANUAL FOR THE REMOTE CONTROLLED SEARCH LIGHT, RCL-100

Y1-03-0266 Rev. A Page | 10 Typical view of a good and clean slip ring that transfers the voltage from the copper tracks to the contacts mounted in

Y1-03-0266 Rev. A Page | 11 Rotation motor. It is actually an assembly that consists of a motor and a gearbox with spindle gear. GEARBOX MOTOR

Y1-03-0266 Rev. A Page | 12 TROUBLESHOOTING Testing the system with all connected. Use a volt/ohm meter set to DC Voltage. Measure from ground to ea

Y1-03-0266 Rev. A Page | 13 No up and down, everything else is OK Disconnect the RED and WHITE wires (in the 6-wire wiring harness leading out of the

Y1-03-0266 Rev. A Page | 14 Lights work but no rotation or elevation and lights will not shut off First, disconnect the coaxial cable from the

Y1-03-0266 Rev. A Page | 15 Need to send the light to ACR for repair? Please send the light to: Technical Service, ACR Electronics Inc. 5757 Ravenswo

Y1-03-0266 Rev. A Page | 16 Recommended Maintenance As with any marine product, proper care and regular maintenance is highly recommended. In orde

Y1-03-0266 Rev. A Page | 17 Parts list 6001 BULB 12V 6003 BULB 24V HRMK 1201 WINDOW GASKET HRMK 1204 BASE GASKET HRMK 1300 FRONT GLASS HRMK 1301 REFL

Y1-03-0266 Rev. A Page | 2 INDEX Troubleshooting tools needed 3 Wiring guide 3 Pointpad / Master controller compatibility 5 12V /

Y1-03-0266 Rev. A Page | 3 Troubleshooting tools needed.  Ohm Meter  Rubbing Alcohol  Wire Brush  Clean Rags  #2 Phillips Screwdriver  Le

Y1-03-0266 Rev. A Page | 4 System Wiring Schematic. MasterRCL-100Point PadSpotlightYellow Lamp PowerGreen Lamp GroundRed Spot UpWhite Spot DownBrown

Y1-03-0266 Rev. A Page | 5 Compatibility of POINTPAD URP with MASTER CONTROLLER URC There are 3 generations of control systems for the RCL 100 searchl

Y1-03-0266 Rev. A Page | 6

Y1-03-0266 Rev. A Page | 7 To remove the head from the base, loosen the 4 screws from the collar and carefully lift the head off the base.

Y1-03-0266 Rev. A Page | 8 To remove the complete Front Frame assembly from the head of the light, remove the front frame and glass assembly. Loosen

Y1-03-0266 Rev. A Page | 9 Complete Reflector/elevation motor assembly.