ACR Electronics PLB-350B Spécifications télécharger pdf (Page 15)

Y1-03-0241C 14

batteries contained in this equipment to make sure they properly label

your package. Call ACR’s Technical Service department at +1 (954)

981-3333 for proper shipping instructions or visit the ACR website in the

Support section entitled “Hazmat, MSDS Sheets, & Info”.

3. Self-Test

ACR strongly recommends performing a Self-test once per month, or at

least two weeks prior to a trip, to allow enough time for service, should

your beacon require it.

A Self-test is initiated by holding the Self-test button ( ) for at least 1

second and less than 5 seconds. Your beacon will sound an initial

“beep” and flash the green LED to signify the test has begun. Four more

beeps will follow. The green LED will flash a second time to indicate

that the Self-test was successful.

NOTE: The “beep” is a very high pitch sound that some people are

unable to hear. Watching the LEDs may be more useful to you.

Components Tested: Data integrity and memory, 406 MHz

synthesizer, RF power/battery, GPS header (if equipped).

If a red LED flashes at the completion of the Self-test, your beacon has

failed. Repeat the Self-test. If the failure persists, contact ACR

Electronics or an authorized Battery Replacement Center to have your

beacon serviced.

NOTE: During a Self-test your beacon will send a 406 MHz signal coded

as self-test to the satellite system. The 121.5 MHz homing signal is

inhibited during Self-test. This allows you to test your beacon any time

during the day without causing false alerts.

Self-Test Sequences

Self-Test Guide

( Green LED Red LED)

Green LED with beep, 4

additional “beeps”, Green LED,

strobe flash

Successful Self-test

Green LED, Less than 4 “beeps”,

Red LED

Failed Self-test: Return unit

to ACR for service

Red LED with beep, 4 additional

“beeps”, Green LED, strobe flash

Successful Self-test: Less

than 24 hours of

transmission life is left in the

batteries.

Red LED with or without beep,

Less than 4 additional “beeps”,

Red LED, strobe flash (PLB-350B

only)

Failed Self-test: Return unit

to ACR for service. Less

than 24 hours of

transmission life is left in the

batteries.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Commentaires sur ces manuels

Pas de commentaire

ACR Electronics PLB-350B Spécifications Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Navigateurs ACR Electronics PLB-350B